What Else Affects Electric Vehicle Range Besides the Battery?
The battery is the core component of an electric vehicle. Now, due to national environmental requirements, batteries must not contain “cadmium ”, which has a certain impact on battery life. It is not that today s batteries are getting worse. Look at it another way: with no “cadmium ” in the battery, the harm to the environment and the human body keeps decreasing, so batteries are becoming greener and more environment-friendly!
Nowadays many electric vehicle users still blame the battery the moment the vehicle cannot run far. Even after testing proves the battery is normal, they still think it is the battery s problem. In fact, there are many reasons why an electric vehicle cannot run far, and the battery is not always the cause. The following situations can also shorten the range.

Wiring problems
Wiring problems are soft faults. All components are fine, but resistance is produced in the connections; where there is resistance there is voltage division, and the larger the current, the larger the voltage drop. With a new battery the lights dim as soon as the throttle is twisted. This problem is very common, and eight or nine out of ten cases of short mileage are caused by it.
Places where resistance is generated
1. The connectors between the controller and the battery, and between the controller and the motor.
Good connectors are gold- or silver-plated, ordinary ones are copper or copper-plated, and poor ones are iron. Over time they oxidize and produce contact resistance. When a large current passes, they heat up, and in serious cases they burn black.
2. Fuse. Poor contact, not clamped tightly or compressed firmly.
3. The ignition lock switch connected to the main circuit.
4. Cold solder joints at the battery welding points.
5. The battery connection wires are too thin, or not copper. Overly long wires are also not good.
6. Wrong wiring, for example connecting the controller s thin red wire to the battery.
7. Poor contact at the battery box output port or contacts.
Battery temperature difference
Battery capacity is usually tested indoors at temperatures above10degrees. In actual riding, outdoor temperatures in northern regions are below0degrees. The capacity drops greatly, so it is normal that the vehicle cannot run far in cold winters. When the temperature rises to25degrees, it returns to normal.25degrees is the normal operating temperature of the battery; for every one degree the temperature falls, the capacity drops by1%. Of course, after years of technical improvement, Xupai batteries are much less affected by temperature.
Besides these harder problems, there are also common ones. The motor is the first thing to think of: high current consumption, for example motor demagnetization. Then mechanical resistance problems, for example insufficient tire pressure, bearings, brakes and so on. So when the electric vehicle cannot run far, do not simply blame the battery; go to a professional repair shop for an inspection first , otherwise you will waste another sum of money!

In addition, to better protect the electric products our customers are using or about to buy, Xupai battery specially gives this warm reminder of the battery maintenance guide for electric products. We hope all friends will attach great importance to it:
1. Do not store the battery in a discharged state for a long time after use. Lead-acid batteries have no memory effect, so remember to recharge right after use. If the battery stays in a discharged state for a long time, deep discharge will end its life and make it unusable. Remember to charge often.
2. When going up bridges, climbing slopes or riding against the wind, shift to the slow gear and reduce speed, to prevent the battery supply current from increasing suddenly and affecting battery life.
3. When starting the vehicle, set the speed to the slow gear. High-current discharge may trigger overcurrent protection and cut off power of the whole vehicle, and the surge current also harms the battery.
4. When accelerating while riding, turn the speed controller slowly to avoid dangers to personal safety from accelerating directly to the highest speed.